 |
Caution:
When building your Skyfort, we recommend at least two people for lifting
and holding logs, frames and other heavy assemblies in position before bolting
or nailing.
Safety:
Wear safety glasses to protect your eyes from flying wood chips when cutting
or drilling. Use a dust mask. Blunt nail points to prevent wood from splitting.
To prevent splinters, sand the corners, edges, and all points of the wood
by wrapping a piece of 80 grit sandpaper around a block of wood and sanding.
Installation
Safety:
-
Consult
the assembly instructions supplied with your particular Skyfort model.
-
Build
the Skyfort according to the plans supplied without altering the design.
If you are unsure of any aspect, please call us on our Toll Free Hotline
1800 773 229
-
Make
sure all hardware is tightened securely.
-
Using
a hacksaw, cut off all protruding threaded ends of bolts and other
fasteners and remove any sharp edges with a metal file as needed.
-
Place
the Skyfort on level ground placing the open end or ends, not less
than 1.9 metres from any structure or obstruction such as a fence,
garage, house, overhanging branches, laundry lines, or electrical
wires.
-
Make
sure your Skyfort playground is not installed over concrete, asphalt,
packed earth or any other hard surface. (a fall onto a hard surface
can result in serious injury.) Remember - soft landings need soft
surfaces
-
Make
sure not to allow children to use your new Skyfort until it is properly
installed.
-
Install
only Peppertown Skyfort accessories approved for use with your Skyfort
playground model.
- Save
the plan for future reference.
If you have any queries concerning
safety, maintenance and installation that you still require further
information about, please contact Peppertown
on Toll Free 1800 773 229.
|
|
